Case Shapes

Aaron Garrett · Post by **Aaron Garrett** » 11 Jan 2004 2:03 pm

This is a dumb question which I'm sure has an obvious answer. The steel cases I've seen tend to be the depth and length of the steel and roughly double the width, with a side compartment for legs, etc. Does anyone sell a case shaped more like a toolbox, i.e. width and length of the steel, but twice the depth, with a compartment for legs, etc. on top? It would seem easier to carry and store this way.

Earnest Bovine · Post by **Earnest Bovine** » 11 Jan 2004 3:50 pm

Dag Wolf · Post by **Dag Wolf** » 11 Jan 2004 3:56 pm

I had a case like that but found it to be harder to carry. A case like this would bump your leg harder than a standard case.

Dag

Aaron Garrett · Post by **Aaron Garrett** » 11 Jan 2004 4:34 pm

Thank you.

Ulf Edlund · Post by **Ulf Edlund** » 11 Jan 2004 4:46 pm

I had a Howard steel with a case like that, but like Dag i found it harder to carry.

Uffe